1. Make a list, note this was my first list of the week and it changed drastically before work day. I'll hunt down the real list at a later date. I decided to remove the engine from the top, not bottom as this list would imply, so several of the steps are not needed, in the wrong order, or omitted entirely. As it were, nothing during prep 1 is even on it.
2. Open door and clean out passenger seat area.
3. Identify front passenger seat bolts, and remove.
4. Identify rear passenger seat bolts, and remove.
5. Remove seat, place back in car as such, layout tools on passenger floor.
6. Pop bonnet and take a breath.
7. Remove hot side charge tubes.
8. Remove filter, maf, intake tube remembering to disconnect vacuum lines and unplug maf.
9. Remove cold side charge tube, again disconnecting vacuum lines.
10. Go inside because it starts to rain, put all tools including jack back in car on passenger floor.
FYI
2. Open door and clean out passenger seat area.
3. Identify front passenger seat bolts, and remove.
4. Identify rear passenger seat bolts, and remove.
5. Remove seat, place back in car as such, layout tools on passenger floor.
6. Pop bonnet and take a breath.
7. Remove hot side charge tubes.
8. Remove filter, maf, intake tube remembering to disconnect vacuum lines and unplug maf.
9. Remove cold side charge tube, again disconnecting vacuum lines.
10. Go inside because it starts to rain, put all tools including jack back in car on passenger floor.
FYI
No comments:
Post a Comment